Serving Industries Worldwide with Manual & Computerized Foam Cutting Equipment

Hand-Held Hot Wire Equipment: Heat Dial Hot Knife Groover

HEAT DIAL HOT KNIFE / GROOVER

Electronic Circuit Board Powered

Variable-Power Control

Lightweight

Stamped Blades

Spring-Loaded Safety Trigger

Heat Dial Hot Knive Foam Cutter

This is limited-time-use tool.
To avoid overheating and damaging the tool, depress the trigger for 15 seconds, then release the trigger for 15 seconds. Continue this cycle for a maximum of 5 minutes. Then let the tool rest for 2-1/2 minutes. Using the tool longer than 5 minutes at a time will cause heat damage and is not covered by the warranty.

HDHKT, Heat Dial Hot Knife Tool -- $243.85

See also: NWFW, Flat Ni-Chrome Wire, per foot -- $10.00

STANDARD2", 4" & 6" BLADES
FOR HEAT DIAL HOT KNIFE

HD200, 2 " Blade, Pack of 2 -- $23.00

HD400, 4" Blade, Pack of 2 -- $24.00

HD600, 6" Blade, Pack of 2 -- $28.00

Hot Knife Groover Plate
6" GROOVER PLATE W/ LINE hotWINDOW
FOR HEAT DIAL HOT KNIFE

This 6" Groove Adapter accomodates blades up to 6" wide. Built-in center window and front pointer for following lines.

Heat Dial Hot Knife Sold Separately

HD6, 6" Groover Plate -- $96.95

See also: NWFW, Flat Ni-Chrome Wire, per foot -- $10.00

Hot Knife Groover Plate with Guide
6" GROOVER PLATE
FOR HEAT DIAL HOT KNIFE

This 6" Groove Adapter accomodates blades up to 6" wide.

Heat Dial Hot Knife Sold Separately